Rear power sliding window — removal and installation Ford F150
Warning: The models covered in this manual are equipped with a Supplemental Restraint System (SRS), more commonly known as air bags. Always disable the airbag system before working in the vicinity of any airbag system component to avoid the possibility of accidental deployment of the airbags, which could cause personal injury (see Chassis electrical system).
Note: If the rear power sliding window is stuck or inoperative it may be necessary to cut the motor cables in order to allow the window to operate or to remove the cable and motor assembly
1. Remove the cab rear wall trim (see Interior trim – removal and installation).
2. Remove the glass sliding panel left and right stop screws.
3. Detach the left and right side cable stays and retaining clips.
4. Disconnect both the left and right side motor cables from the glass and rail track.
5. Disconnect the electrical connection at the motor.
6. Remove the three mounting bolts securing the motor to the rear wall.
7. Remove the motor and cable assembly.
8. Installation is the reverse of removal.